Simpler Networks HP200PT64 Uživatelský manuál stáhnout pdf (Strana 34)

The table below provides details about the section shown in figure above.

Field

Description

Default Priority

The priority level assigned to non-prioritized traffic.

Criteria (1 & 2)

None, Custom, 8021p, TOS, ARP, TCP_8021p, or TCP_TOS

The QoS criteria are applied as follows:

a) Criterion 1 is processed first (and Criterion 2 second)

b) If Criterion 1 is met, Criterion 2 will NOT be applied

Thus, Criterion 2 should be more general than Criterion 1. There are also certain

incompatibilities that arise between these criteria, as outlined in the table below.

If Criterion 1 Protocol is …

Then Criterion 2 can be …

Origin IP / Destination IP

None of these protocols.

TCP with port UDP Protocol, Origin and destination IP

address for UDP packets

UDP with port

TCP Protocol, Origin and destination IP

address for TCP packets

Custom Criterion Configuration

Offset

A decimal ordinal number representing the starting

byte for the pattern in the data packet.

Pattern (hex)

Defines the pattern (8-byte size).

Bitmask (hex)

A bitwise operation applied to the pattern.

Class Offset

A decimal ordinal number representing the starting

byte for the class pattern in the data packet.

Class Bitmask (hex)

A bitwise operation applied to Class Patterns 1-8.

Class Pattern 1-8 (hex)

Defines a class pattern (8-byte size).

Class Priority 1-8

This value ranges from 0 to 7, with 0 being the

lowest priority and 7 the highest priority.

SECURITY STATUS

This section allows you to change (or remove) the configuration password, used

to access the WUI, and perform a factory reset to recover default settings.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Žádné komentáře

Simpler Networks HP200PT64 Uživatelský manuál Strana 34